Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 299 (COMMON SPECS & PROCEDURES)BRAKESDISC BRAKESDISC BRAKE TORQUE SPECIFICATIONS
1999 GMC Forward Control 5.7 R, Automatic
Disc Brake Torque Specifications
1999 GMC Forward Control 5.7 R, AutomaticSECTION Disc Brake Torque Specifications
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
DISC BRAKE TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| ABS Sensor Wire | 13 (17) |
| Brake Hose Fitting Bolt (Rear Wheel) | 40 (54) |
| Caliper Bracket-To-Knuckle Mounting Bolt (Dual Piston Front Caliper) | 133 (180) |
| Caliper Bracket-To-Mounting Plate Bolt (Rear Wheel) | 52 (70) |
| Caliper Guide Pin Mounting Bolt (Dual Piston Front Caliper) | 85 (115) |
| Caliper Mounting Bolt (2-Wheel Disc Brakes) | 38 (51) |
| Front Flex Hose Bolt (Front Wheel) | 40 (54) |
| Guide Pin Bolt (Rear Caliper) | 23 (31) |
| Mounting Brake Nut (Rear Wheel) | 47 (65) |
| Rear Brake Backing Plate Mounting Bolts | 48 (65) |
| Wheel Nuts | 100 (136) |
| INCH Lbs. (N.m) | |
| Bleeder Valve | 110 (12) |
| Park Brake Cable Adjusting Nut | 31 (4) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.