Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 294 (AIR BAG RESTRAINT SYSTEMS)DISABLING & ACTIVATING AIR BAG SYSTEMACTIVATING SYSTEM
1999 GMC Forward Control 5.7 R, Automatic
Activating System
1999 GMC Forward Control 5.7 R, AutomaticSECTION Activating System
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure ignition is off and key is removed. Connect driver and passenger head impact air bag module connectors. See Figure. Install Connector Position Assurance (CPA) clips. Raise headliner and install coat hooks. Install left and right D-pillar trim panels. Install rear upper head liner trim panel.
- Connect passenger-side air bag module connector. See Figure. Install CPA clip. Connect driver-side air bag module connector. See Figure. Install CPA clip. Install AIR BAG fuse. Check SIR system for proper operation. Go to SYSTEM OPERATION CHECK .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.