Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 279 (ENGINE CONTROLS - SYSTEM & COMPONENT TESTING)FUEL SYSTEMSFUEL TANK LEAK TESTDIAGNOSTIC AIDS
1999 GMC Forward Control 5.7 R, Automatic
Diagnostic Aids
1999 GMC Forward Control 5.7 R, AutomaticSECTION Diagnostic Aids
WARNING: This page is about a different car, the 2003 Cadillac Seville and 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
- Operate the vehicle under the condition of the customers concern. Under high temperature conditions, fuel vapors may increase to the point of EVAP canister vapor saturation. Fuel vapors would then be released into the atmosphere. Once the engine is running and EVAP purge is enabled, all fuel vapor release would be eliminated.
- Test for fuel leaking in the fuel tank and the fuel feed and return pipes.
- Test for fuel vapor leaks in the fuel tank, fill limiter vent valve and rollover valves, the fuel fill pipe, hose and fuel fill cap, the fuel sender housing and seal, the Fuel Tank Pressure (FTP) sensor seal and the EVAP vapor pipe.
- Movement of the EVAP pipes or fuel pipes may help find an intermittent condition.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.