Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM DEACTIVATION PROCEDURES)GENERAL MOTORSDISABLING & ACTIVATING AIR BAG SYSTEMACTIVATING SYSTEM (CATERA)
1999 GMC Forward Control 5.7 R, Automatic
Activating System (Catera)
1999 GMC Forward Control 5.7 R, AutomaticSECTION Activating System (Catera)
WARNING: This page does not describe the selected car, but rather 114 other vehicles, including the 2000 Saturn SW2, 2000 Saturn SL2, 2000 Saturn SL1, 2000 Saturn SL, and 2000 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure ignition switch is in LOCK position with key removed. Connect right-hand (passenger) side air bag 2-pin Yellow SIR connector, if equipped. Install CPA clip. Connect passenger seat belt pretensioner 2-pin connector. Repeat procedure for driver seat belt pretensioner 2-pin connector and side air bag 2-pin Yellow SIR connector, if equipped.
- Connect passenger air bag 2-pin Yellow SIR connector. Install CPA clip. Install air bag trim cover. Connect driver air bag module wiring harness connector to steering wheel SIR coil connector. Install upper and lower steering column covers.
- Staying well away from inflator modules, turn ignition switch to ON position. Ensure AIR BAG warning light flashes 7 times, and then turns off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.