Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pcm Programming (SEBRING Convertible, SEBRING Sedan & Stratus Sedan)
This procedure needs to be completed every time a PCM is replaced. Secret key data must be programmed into SKIM from PCM. See SKIM MODULE (SEBRING CONVERTIBLE, SEBRING SEDAN & STRATUS SEDAN) . Connect scan tool to Data Link Connector (DLC). Turn ignition switch to ON position. Using scan tool, select THEFT ALARM, SKIM then MISCELLANEOUS. Then select PCM REPLACED. Enter secured access mode by entering 4-digit pin. Press enter to transfer secret key to new PCM. Now enter VIN and mileage into new PCM. Using scan tool, clear DTCs from ABS and ACM.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.