Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 105 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REMOVAL & INSTALLATIONAIR BAG MODULESREMOVAL & INSTALLATION (DRIVER-SIDE)
1999 GMC Forward Control 5.7 R, Automatic
Removal & Installation (Driver-side)
1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal & Installation (Driver-side)
WARNING: This page is about a different car, the 2002 Buick Park Avenue. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Turn ignition on. Turn steering wheel so 2 holes on back of steering wheel are accessible. Install Air Bag Module Remover (J-44248) into holes. See Fig 1. Release driver-side air bag module spring clips. Turn steering wheel 180 degrees and repeat procedure for remaining 2 spring clips.
- Remove Connector Position Assurance (CPA) clip from driver-side air bag connector and disconnect connector. See Fig 2. Remove horn ground lead from steering wheel. Turn horn contact lead 1/4 turn counterclockwise to release from steering wheel. Remove horn contact lead from steering column cam tower. Remove driver-side air bag module.
- To install, reverse removal procedure. Activate air bag system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.