Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 104 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)COMPONENT LOCATIONS
1999 GMC Forward Control 5.7 R, Automatic
Component Locations
1999 GMC Forward Control 5.7 R, AutomaticSECTION Component Locations
WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS
| Component | Location | |
|---|---|---|
| AIR BAG warning light | Instrument Panel Cluster (IPC) | |
| Driver-side air bag module | On steering wheel | |
| Front end discriminating sensor | Lower front frame rail | |
| Knee bolsters | Lower driver & passenger-side instrument panel | |
| Passenger-side air bag module | Passenger-side instrument panel | |
| Sensing & Diagnostic Module (SDM) | Under passenger front seat | |
| Side impact air bag module | Driver-side front seat outer seat back | |
| Side Impact Sensor (SIS) | ||
| Impala | Driver-side lower B-pillar | |
| Monte Carlo | Driver-side front door | |
| SIR coil assembly | Below steering wheel | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.