SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 100 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REMOVAL & INSTALLATIONINSTRUMENT PANEL CLUSTER (IPC)REMOVAL & INSTALLATION
1999 GMC Forward Control 5.7 R, Automatic

Removal & Installation

1999 GMC Forward Control 5.7 R, AutomaticSECTION Removal & Installation
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Remove IPC trim bezel. Remove defroster grille. Release 4 IPC retaining pins. Pull IPC rearward to remove. To install, reverse removal procedure. When IPC is fully seated, an audible snap will be heard. Activate air bag system. Go to SIR DIAGNOSTIC SYSTEM CHECK .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.