Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1999FORWARD CONTROL 5.7 R, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 100 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)DIAGNOSTIC TESTSDTC B0051: DEPLOYMENT COMMANDEDDIAGNOSTIC PROCEDURE
1999 GMC Forward Control 5.7 R, Automatic
Diagnostic Procedure
1999 GMC Forward Control 5.7 R, AutomaticSECTION Diagnostic Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- If SIR diagnostic system check has been performed, go to next step. If SIR diagnostic system check has not been performed, go to SIR DIAGNOSTIC SYSTEM CHECK .
- Turn ignition off. If air bags have deployed, go to step 5. If air bags have not deployed, go to next step.
- Inspect vehicle and undercarriage for signs of impact. If impact has occurred, go to step 5. If no impact has occurred, go to next step.
- Replace SDM. See SENSING & DIAGNOSTIC MODULE (SDM) under REMOVAL & INSTALLATION. Go to step 6.
- Replace components and perform inspections as required following an accident. See POST-COLLISION INSPECTION . Go to next step.
- Reconnect all SIR components. Using scan tool, clear DTC's. Go to SIR DIAGNOSTIC SYSTEM CHECK .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.