Content Theft State

1998 GMC Envoy 2WD V6-4.3L VIN WSECTION Content Theft State

Security Data:




Range: OFF/ IDLE/ DISARMED/ READY TO ARM/ ARM INITIATED/ ARM DELAY/ ALARM/ARMED
The state that displays refers to the state of the content theft system.

OFF STATE displays when ignition 1 is ACTIVE and All of the doors, including the rear glass. are closed.

IDLE STATE displays when ignition 1 is ACTIVE and under the following conditions:
^ Any door is open.
^ The rear glass is open.

DISARM STATE displays ignition 1 transforms from ACTIVE to INACTIVE and under the following conditions:
^ All of the doors are closed.
^ The rear glass is closed.

READY TO ARM STATE displays when ignition 1 transforms from ACTIVE to INACTIVE and under the following conditions:
^ Any door is open.
^ The rear glass is open.

ARM INITIATED STATE displays when ignition 1 is INACTIVE and under the following conditions:
^ All of the doors are locked.
^ The rear glass is closed.
^ Any door is open.
^ The rear glass is open.

ARM DELAY STATE displays when ignition 1 is INACTIVE and under the following conditions:
^ The vehicle is in the armed state.
^ All of the doors are closed.
^ The rear glass is closed.

ARMED STATE displays when the vehicle is in the ARM DELAY state and all of the inputs are monitored in order to determine whether to alarm or disarm the system. In the ARM DELAY state, ignition 1 is INACTIVE, and all of the doors and the rear glass are closed.

ALARM STATE displays when the vehicle is in the ARMED STATE and the system detects a violation on any of the inputs being monitored.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.