Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1998ENVOY 2WD V6-4.3L VIN WREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINESERVICE AND REPAIRENGINE OVERHAUL (UNIT REPAIR)REPAIR INSTRUCTIONSCYLINDER HEAD REMOVAL
1998 GMC Envoy 2WD V6-4.3L VIN W
Cylinder Head Removal
1998 GMC Envoy 2WD V6-4.3L VIN WSECTION Cylinder Head Removal
1. Remove the spark plugs.
2. Remove the spark plug wire supports and bolts.
3. Remove the coolant sensor (if applicable).
4. Remove the cylinder head bolts.
NOTICE: After removal, place the cylinder head on two wood blocks to prevent damage.
5. Remove the cylinder head.
6. Remove and discard the gasket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.