Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal & Installation
1996 GMC Savana Special 6.5 YSECTION Removal & Installation
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 1996 Chevrolet Chevy Van, 1995 GMC Yukon, 1995 GMC Vandura Special, 1995 GMC Vandura, and 1995 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
- Remove air cleaner assembly. Disconnect electrical connector from TP sensor. Remove attaching screws, lock washers, retainers, and TP sensor.
- To install, reverse removal procedure. Adjust TP sensor to specification. See ADJUSTMENTS - 6.5L DIESEL article in the ENGINE PERFORMANCE section. When replacing a TP sensor, ensure correct part number is used. Use Loctite on TP sensor attaching screws.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.