Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
TP Sensor Learn (CADILLAC)
If a NEW TP sensor or throttle body is installed, EBTCM must learn new TP sensor idle position voltage. This procedure is necessary to ensure effective engine management. If an improper TP sensor offset is maintained by the PCM, a high idle at closed throttle or stall condition may occur.
- Turn ignition on (engine off). Wait for 30 seconds.
- Turn ignition to LOCK position. Wait for 30 seconds.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.