Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1996SAVANA SPECIAL 6.5 YREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSPOWER WINDOW SYSTEMTESTINGLEFT WINDOW DOES NOT OPERATE
1996 GMC Savana Special 6.5 Y
Left Window Does Not Operate
1996 GMC Savana Special 6.5 YSECTION Left Window Does Not Operate
- Disconnect left window switch connector. Disconnect left window motor connector. Connect self-powered test light between Dark Blue wire terminals at left window switch and left window motor connectors. If test light illuminates, go to next step. If test light does not illuminate, repair open in Dark Blue wire between left window switch and left window motor.
- Connect self-powered test light between Brown wire terminals at left window switch and left window motor connectors. If test light illuminates, go to next step. If test light does not illuminate, repair open in Brown wire between left window switch and left window motor.
- Connect self-powered test light between Dark Blue and Black wire terminals at left window switch connector. If test light illuminates, go to next step. If test light does not illuminate, replace left window switch.
- Connect self-powered test light between Brown and Black wire terminals at left window switch connector. If test light illuminates, go to next step. If test light does not illuminate, replace left window switch.
- Connect self-powered test light between Yellow wire at left window switch connector and ground. Turn ignition switch to ACC position. If test light illuminates, go to next step. If test light does not illuminate, repair open in Yellow wire between left window switch and fuse block.
- Reconnect left window switch connector. Connect test light between ground and Dark Blue wire at left window motor connector. Press left window switch to UP position. If test light illuminates, go to next step. If test light does not illuminate, replace left window switch.
- Connect test light between Brown wire at left window motor connector and ground. Press left window switch to DOWN position. If test light illuminates and no mechanical problems exist, replace left window motor. If test light does not illuminate, replace left window switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.