Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1995VANDURA SPECIAL 5.7 KLABOR TIMESTRANSMISSIONAUTOMATIC TRANSTRANSMISSION ASSEMBLYREMOVAL & INSTALLATION
1995 GMC Vandura Special 5.7 K
Removal & Installation
1995 GMC Vandura Special 5.7 KSECTION Removal & Installation
TRANS ID - 4L80E
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 4.3 | C | |||
| Combination Procedure: BAND: Remove & Replace: | ||||
| Front | 0.7 | A | ||
| Rear or Both | 1.7 | A | ||
| Combination Procedure: CLUTCH PLATES: Remove & Replace: | ||||
| Direct | 1.1 | A | ||
| Forward | 1.1 | A | ||
| Forward & Direct | 1.5 | A | ||
| Fourth Speed | 1.0 | A | ||
| Intermediate | 1.1 | A | ||
| Intermediate & Direct | 1.5 | A | ||
| Overrun | 0.9 | A | ||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.3 | C | |||
| Combination Procedure: OUTPUT SHAFT: Remove & Replace: | ||||
| 2.2 | B | |||
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: | ||||
| 0.1 | C | |||
| Combination Procedure: TRANS OIL PUMP: Overhaul Removed: | ||||
| 0.5 | B | |||
| Combination Procedure: TRANS OIL PUMP: Remove & Replace: | ||||
| 0.4 | B | |||
| Combination Procedure: TRANS OIL PUMP BUSHINGS & SEAL: Remove & Replace: | ||||
| 0.3 | B | |||
| Combination Procedure: TRANS OIL PUMP SEAL: Remove & Replace: | ||||
| 0.2 | B | |||
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: | ||||
| 0.6 | C | |||
| Combination Procedure: TRANSMISSION CASE: Remove & Replace: | ||||
| 2.5 | A | |||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.