Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC 65, App No. 3 Circuit Range Fault: Notes
Accelerator Pedal Position (APP) module provides a voltage signal that changes relative to accelerator position. There are 3 sensors located within APP module that are scaled differently. DTC 65 will set when PCM has recognized a skewed (mis-scaled) sensor. PCM compares all 3 sensors to each other and determines if there is a 6 percent difference between APP No. 1 and APP No. 2, and a 10 percent difference to APP No. 3.
PCM will ignore input from APP No. 3. A current and history DTC will set but will not turn on SERVICE THROTTLE SOON light. Throttle will operate normally as long as there is only one sensor malfunctioning. If 2 different APP sensors have a malfunction, SERVICE THROTTLE SOON light will light and PCM will limit power. If 3 APP sensors malfunction, SERVICE THROTTLE SOON light will light and PCM will only allow engine to operate at idle.
- This step determines if a good 5-volt reference is present.
- This step checks for an open in ground circuit.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.