Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 43, Knock Sensor Without Spark Module (Dual Sensors): Notes
1995 GMC Suburban K2500, 6.5 FSECTION Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1995 GMC Vandura, 1995 GMC Rally, 1995 GMC Pickup, 1995 Chevrolet Sportvan, and 1995 Chevrolet Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- Tests for 5-volt signal applied by control module.
- An improperly installed sensor can prevent knock sensor from grounding to block.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.