Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 86, Low Gear Ratio Error - All Models: Notes
1995 GMC Suburban K2500, 6.5 FSECTION Notes
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 1996 Chevrolet Chevy Van, 1995 GMC Vandura Special, 1995 GMC Vandura, 1995 GMC Sonoma, and 1995 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.
Control module calculates ratio based on transmission input speed and output speed sensor readings. Control module compares known ratio to calculated ratio.
NOTE:
Test numbers refer to numbers on diagnostic chart.
- An out-of-calibration transmission range pressure switch could falsely indicate actual transmission range.
- This test verifies proper ratio.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.