Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1995FORWARD CONTROL 4.3 Z, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALSTARTERSTARTING SYSTEMTORQUE SPECIFICATIONS
1995 GMC Forward Control 4.3 Z, Standard
Torque Specifications
1995 GMC Forward Control 4.3 Z, StandardSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| A/C Compressor Brace Nut & Bolt | 23 (31) | ||
| Crossmember-To-Frame Bolts (A/T) | 56 (76) | ||
| Crossmember-To-Frame Bolts (M/T) | 34 (46) | ||
| Engine Mount Bolts | |||
| 2.2L | 39 (53) | ||
| 4.3L | |||
| Blazer & Jimmy | 61 (83) | ||
| Sonoma & Pickup | 49 (66) | ||
| Exhaust Pipe-To-Manifold (2.2L) | 15 (20) | ||
| Exhaust Pipe-To-Manifold (4.3L) | 20 (27) | ||
| Starter Bracket-To-Block Bolt | 32 (43) | ||
| Starter Mounting Bolts | |||
| 2.2L & 4.3L | 32 (43) | ||
| 5.0L, 5.7L, 6.5L & 7.4L | 35 (47) | ||
| 3.1L & 3.8L | 32 (43) | ||
| 4.3L, 5.7L & 7.4L (1) | 24 (33) | ||
| 6.5L (1) | 33 (45) | ||
| Transmission Mount-To-Crossmember | 38 (52) | ||
| Transmission Mount-To-Transmission Bolt | 35 (47) | ||
| INCH Lbs. (N.m) | |||
| Bracket-To-Starter Nuts | 97 (11) | ||
| Starter Shield Nuts | 106 (12) | ||
|
|||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.