Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1995C3500 HD 6.5 F, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 39 (ENGINE CONTROLS - REMOVE/INSTALL/OVERHAUL - 5.2L GASOLINE)IGNITION SYSTEMDISTRIBUTORNOTES
1995 GMC C3500 HD 6.5 F, Automatic
Ignition System: Distributor: Notes
1995 GMC C3500 HD 6.5 F, AutomaticSECTION Notes
WARNING: This page is about a different car, the 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Base ignition timing is not adjustable on 5.2L engine. Base ignition timing and timing advance are controlled by the PCM. Since a conventional timing light cannot be used to adjust distributor after installation, ensure distributor is returned to its original position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.