Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Model Identification: Terminology
Due to Federal government requirements, manufacturers may use names and acronyms for systems and components different than those used in previous years. The following table will help eliminate confusion when dealing with these components and systems. Only relevant components and systems whose names have changed from current General Motors Corp. terminology have been listed.
| Former Name Or Acronym | New Name Or Acronym |
|---|---|
| ALDL | Data Link Connector (DLC) |
| CHECK ENGINE Light | Malfunction Indicator Light (MIL) |
| CTS | Engine Coolant Temp. (ECT) Sensor |
| Diagnostic Circuit Check | On-Board Diagnostic (OBD) System Check |
| ESC System | Knock Sensor (KS) System |
| EST System | Ignition Control (IC) System |
| MAT Sensor | Intake Air Temperature (IAT) Sensor |
| Park/Neutral (P/N) Switch | Park/Neutral Position (PNP) Switch |
| Port Fuel Injection | Multi-Port Fuel Injection |
| Scan Data | Scan Tester (ST) Data |
| SERVICE ENGINE SOON Light | Malfunction Indicator Light (MIL) |
| Thermostatic Air Cleaner (TAC) | Air Cleaner (ACL) |
| Throttle Position Sensor (TPS) | Throttle Position (TP) Sensor |
| Throttle Position Switch | Closed Throttle Position (CTP) Switch |
| Throttle Position Switch | Wide Open Throttle (WOT) Switch |
| Viscous Converter Clutch (VCC) | Torque Converter Clutch (TCC) |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.