Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Speed (Cruise) Control Switch
Disconnect speed control switch 4-pin connector. Using an ohmmeter, check for continuity at speed control switch. See Fig 1 . If continuity is not as specified in SPEED CONTROL SWITCH CONTINUITY table, replace defective speed control switch.
| Brake Pedal Position | Check Between Terminal Nos. | Continuity |
|---|---|---|
| OFF | 1 & 4 | Yes |
| ON | 1 & 4 | Yes |
| ON | 1 & 2 | Yes |
| ON | 2 & 4 | Yes |
| ON & SET | 1 & 2 | Yes |
| ON & RESUME | 1 & 3 | Yes |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.