SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1992SUBURBAN 1/2 TON 2WD V8-350 5.7LREPAIR AND DIAGNOSISSTARTING AND CHARGINGCHARGING SYSTEMDIAGRAMSDIAGNOSTIC AIDSCONNECTOR, SPLICING AND TERMINAL REPAIRWEATHER PACK CONNECTORS
1992 GMC Suburban 1/2 Ton 2WD V8-350 5.7L

Weather Pack Connectors

1992 GMC Suburban 1/2 Ton 2WD V8-350 5.7LSECTION Weather Pack Connectors


Fig. 21 Typical Weather Pack Connector and Terminal:






PROCEDURE
1 Separate the connector halves.
2. Open secondary lock. A secondary lock aids in terminal retention and is usually molded to the connector.
3. Grasp the lead and push the terminal to the forward most position. Hold the lead at this position.
4. Insert the Weather Pack terminal removal tool into the front (mating end) of the connector cavity until it rests on the cavity shoulder.
5. Gently pull on the lead to remove the terminal through the back of the connector.

NOTE: Never use force to remove a terminal from a connector.

6. Inspect the terminal and connector for damage. Repair as necessary.
7. Reform the lock tang and reseat terminal in connector body.
8. Close secondary locks and join connector halves.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.