Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Valve Body: Reassembly
For reassembly, reverse disassembly procedure. Ensure all components are installed in correct location. See Fig 1 . Ensure pins are fully installed and do not extend into machined areas. Note position of valve lands and bushing passages.
| Item No. | Description |
|---|---|
| 1 | Valve Body |
| 2 | Pin |
| 3 | Throttle Valve |
| 4 | Spring |
| 5 | Throttle Valve Plunger |
| 6 | Sleeve |
| 7 | 3-4 Valve |
| 8 | 3-4 Relay Valve |
| 9 | Plug |
| 10 | Cup Plug |
| 11 | 4th Clutch Pressure Switch |
| 12 | Throttle Valve Limit Valve |
| 13 | Throttle Valve Plug |
| 14 | Retainer |
| 15 | 1-2 Accumulator Valve |
| 16 | Valve Sleeve |
| 17 | Line Bias Valve |
| 18 | 3-4 Pulse Pressure Switch |
| 19 | 3-2 Control Valve |
| 20 | 3rd Clutch Pressure Switch |
| 21 | Manual Valve |
| 22 | T.C.C. Pressure Switch |
| 23 | Modulator Downshift Valve |
| 24 | Modulator Upshift Valve |
| 25 | 3-4 Throttle Valve Sleeve |
| 26 | 3-4 Throttle Valve Spring |
| 27 | 3-4 Throttle Valve |
| 28 | 3-4 Shift Valve |
| 29 | 2-3 Shift Valve |
| 30 | 2-3 Throttle Valve |
| 31 | 2-3 Throttle Valve Spring |
| 32 | 2-3 Throttle Valve Sleeve |
| 33 | 1-2 Throttle Valve Sleeve |
| 34 | 1-2 Throttle Valve Spring |
| 35 | 1-2 Throttle Valve |
| 36 | 1-2 Shift Valve |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.