Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1992JIMMY BASE, 2D UTILITY, 4.3 Z, RWD, STANDARDREPAIR AND DIAGNOSISSTEERINGPOWER STEERINGSTEERING SYSTEM - POWERREMOVAL & INSTALLATIONPOWER STEERING PUMPINSTALLATION (ALL MODELS)
1992 GMC Jimmy Base, 2D Utility, 4.3 Z, RWD, Standard
Installation (All Models)
1992 GMC Jimmy Base, 2D Utility, 4.3 Z, RWD, StandardSECTION Installation (All Models)
- To install, reverse removal procedure. Use Pulley Installer (J-25033-B) to install pulley. Install pulley flush with end of pump shaft plus or minus .010" (.25 mm). Tighten bolts and nuts to specifications. See TORQUE SPECIFICATIONS table. Fill reservoir (if necessary). Bleed air from system. See HYDRAULIC SYSTEM BLEEDING under LUBRICATION.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.