Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1991S15 JIMMY 4D UTILITY, 4WD, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - SYSTEM/COMPONENT TESTSMISCELLANEOUS ECM CONTROLSC-8, TRANSMISSIONSHIFT LIGHT (MANUAL TRANSMISSION)
1991 GMC S15 Jimmy 4D Utility, 4WD, Standard
Shift Light (Manual Transmission)
1991 GMC S15 Jimmy 4D Utility, 4WD, StandardSECTION Shift Light (Manual Transmission)
- These tests assume a shift light problem exists. Use this procedure only if the light will not illuminate, or illuminates all the time.
- Turn ignition on, with engine off. Note shift light. Shift light should not be on. If light is on, check for a short to ground between the bulb and ECM or a for bad ECM.
- With ignition on and engine off, ground test terminal "B" of ALDL connector. SERVICE ENGINE SOON light should start to flash and shift light should come on. If light comes on, go to next step. If SERVICE ENGINE SOON light does not flash, perform DIAGNOSTIC CIRCUIT CHECK as described in BASIC TESTING article in this section.
- If shift light does not come on, ground Tan/Black light driver wire at ECM terminal using a jumper wire. See Fig 1. If light still does not come on, check for blown GAGES fuse, blown bulb or open circuit between fuse and ECM. If light comes on when grounding ECM terminal with a jumper wire, problem is a bad ECM connection or bad ECM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.