Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1984PICKUP K2500, 5.7 M, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 10 (SERVICING - M/T)ADJUSTMENTSSHIFT LINKAGETRANSAXLES
1984 GMC Pickup K2500, 5.7 M, Standard
Shift Linkage: Transaxles
1984 GMC Pickup K2500, 5.7 M, StandardSECTION Transaxles
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1984 Plymouth Voyager, 1984 Dodge Ramcharger, 1984 Dodge Ram Wagon, 1984 Dodge Ram Van, and 1984 Dodge Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Working over left front fender, remove lock pin from transaxle selector shaft housing. Reverse lock pin, long end down, and insert lock pin into same threaded hole while pushing selector shaft into selector housing. A hole in selector shaft will align with lock pin, allowing lock pin to be screwed into housing. This operation locks selector shaft in 1-2 neutral position.
- Remove gearshift knob, retaining nut, and pull-up ring. Remove boot from console and remove console. Install 2 cable adjusting pins. Tighten selector cable adjusting screw to 55 INCH lbs. (6 N.m). Tighten crossover cable adjusting screw to 55 INCH lbs. (6 N.m). See Fig 1 .
- Install console, boot, pull-up ring, retaining nut and gearshift knob. Remove lock pin from selector shaft housing and reinstall lock pin (so long end is up) in selector shaft housing. Tighten lock pin to 106 INCH lbs. (12N.m). Check for shift into first and reverse. Check for lockout in reverse.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.