Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
All Models
Remove instrument cluster and remove all cluster light assemblies. Remove printed circuit retaining screws. Remove fuel, temperature, and ammeter terminal nuts holding printed circuit to cluster cover. Remove printed circuit from rear of instrument cluster. To install, reverse removal procedure while noting that retaining screws serve as ground for printed circuit and must be properly reinstalled to provide proper ground connection.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.