Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC1966I1000 STANDARD TRANS, TRANS MFR CD 435GAREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICALGENERAL MOTORS 4-CYL ENGINESENGINE OILINGOIL PUMPINSTALLATION
1966 GMC I1000 Standard Trans, Trans Mfr CD 435GA
Oil Pump: Installation
1966 GMC I1000 Standard Trans, Trans Mfr CD 435GASECTION Installation
Apply sealer to end of pipe and tap into place. Install idler gear in pump body with smooth side of gear toward cover opening.
NOTE:
Bottom of screen must be parallel with bottom of pan.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.