Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2022TRANSIT CONNECT TITANIUM, GASREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 349 (ENGINE SYSTEM - GENERAL INFORMATION)GENERAL PROCEDURESPOWERTRAIN DRIVETRAIN MOUNT NEUTRALIZING
2022 Ford Transit Connect Titanium, Gas
Powertrain Drivetrain Mount Neutralizing
2022 Ford Transit Connect Titanium, GasSECTION Powertrain Drivetrain Mount Neutralizing
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
For information on Ford Color Coded Illustrations refer to OEM COLOR CODING .
Adjustment
NOTE:
Refer to the appropriate section and procedure for special instructions on loosening and tightening mount fasteners.
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- Loosen, but do not remove, the powertrain/drivetrain mount fasteners.
- Lower the vehicle.
-
NOTE: Do not twist or strain the powertrain/drivetrain mounts or damage to the mounts may occur.
Start the vehicle and move it in forward 0.6 m (1.97 ft) - 1.2 m (3.94 ft). Then move the vehicle in reverse the same distance.
- Raise and support the vehicle.
- Tighten the powertrain/drivetrain mount fasteners.
- Lower the vehicle.
- Test the system for normal operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.