Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2022TRANSIT CONNECT TITANIUM, GASREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 175 (ELECTRONIC ENGINE CONTROLS - 6.2L V8)REMOVAL AND INSTALLATIONPOWERTRAIN CONTROL MODULE (PCM)INSTALLATION
2022 Ford Transit Connect Titanium, Gas
Powertrain Control Module (PCM): Installation
2022 Ford Transit Connect Titanium, GasSECTION Installation
WARNING: This page is about a different car, the 2019 Ford F-350 Super Duty and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse the removal procedure.
-
NOTE: This step is only necessary when installing a new component.
Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Refer to: Module Programming .
- Carry out the Parameter Reset procedure. Refer to: Anti-Theft Key Programming - Scan Tool .
- Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.