Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2022MUSTANG GT PREMIUM, 2D CONVERTIBLE, AUTOMATIC TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSCRUISE CONTROL - VEHICLES WITH: ADAPTIVE CRUISE CONTROLDIAGNOSIS AND TESTINGCRUISE CONTROLDTC CHARTSDTC CHART: PCM
2022 Ford Mustang GT Premium, 2D Convertible, Automatic Trans
DTC Chart: PCM
2022 Ford Mustang GT Premium, 2D Convertible, Automatic TransSECTION DTC Chart: PCM
PCM DTC Chart
| DTC | Description | Action |
|---|---|---|
| P0504:00 | Brake Switch A/B Correlation: No Sub Type Information | GO to Pinpoint Test C |
| P0572:00 | Brake Switch A Circuit Low: No Sub Type Information | GO to Pinpoint Test C |
| P0573:00 | Brake Switch A Circuit High: No Sub Type Information | GO to Pinpoint Test C |
| P0833:00 | Clutch Pedal Switch "B" Circuit: No Sub Type Information | For 2.3L engines, GO to Pinpoint Test E For 5.0L engines, GO to Pinpoint Test F |
| P170A:00 | Clutch Switch Out Of Self-Test Range: No Sub Type Information | For 2.3L engines, GO to Pinpoint Test E For 5.0L engines, GO to Pinpoint Test F |
| P1703:00 | Brake Switch Out Of Self-Test Range: No Sub Type Information | GO to Pinpoint Test C |
| P1935:00 | Brake Switch Sensor/Signal: No Sub Type Information | GO to Pinpoint Test C |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.