Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2022MUSTANG GT PREMIUM, 2D CONVERTIBLE, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (ACCELERATION CONTROL - ENGINE IGNITION SYSTEM)CRUISE CONTROL SYSTEM DTCSADAPTIVECRUISE CONTROL MODULE (CCM)
2022 Ford Mustang GT Premium, 2D Convertible, Automatic Trans
Cruise Control Module (CCM)
2022 Ford Mustang GT Premium, 2D Convertible, Automatic TransSECTION Cruise Control Module (CCM)
| DTC | Description | Action |
|---|---|---|
| B142E:78 | Forward Looking Sensor Horizontal Alignment: Alignment or Adjustment Incorrect | GO to Pinpoint Test G |
| B1432:78 | Forward Looking Sensor Vertical Alignment: Alignment or Adjustment Incorrect | GO to Pinpoint Test G |
| B1433:54 | Forward Looking Sensor Alignment: Missing Calibration | GO to Pinpoint Test G |
| C1001:08 | Vision System Camera: Bus Signal/Missing Failure | GO to Pinpoint Test H |
| C1A67:96 | Forward Looking Sensor: Component Internal Failure | GO to Pinpoint Test I |
| C1A67:97 | Forward Looking Sensor: Component or System Operation Obstructed or Blocked | GO to Pinpoint Test J |
| C1A67:98 | Forward Looking Sensor: Component or System Over Temperature | GO to Pinpoint Test K |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | GO to Pinpoint Test L |
| U2300:55 | Central Configuration: Not Configured | GO to Pinpoint Test L |
| U3000:41 | Control Module: General Checksum Failure | GO to Pinpoint Test M |
| U3000:42 | Control Module: General Memory Failure | GO to Pinpoint Test M |
| U3000:44 | Control Module: Data Memory Failure | GO to Pinpoint Test M |
| U3000:49 | Control Module: Internal Electronic Failure | GO to Pinpoint Test M |
| U3002:62 | Vehicle Identification Number: Signal Compare Failure | GO to Pinpoint Test N |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test O |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test P |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.