Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC U053B: Invalid Data Received from Image Processing Module A: Description
The IPMA is integrated into the interior rear view mirror.
The PSCM monitors the HS-CAN messages when the ignition has been on for more than 5 seconds, the voltage to the PSCM is greater than 10 volts and there are no DTCs present inhibiting PSCM operation.
The IPMA uses input from several sensors and components to gather vehicle data, then sends this data to the PSCM. If the data is corrupted or invalid, the IPMA sends out "invalid", "fault" or "unknown" instead of the actual sensor data. For a list of the messages sent to the PSCM from the IPMA, refer to the Network Message List in Description and Operation in the Power Steering article.
- DTC U053B:00 (Invalid Data Received from Image Processing Module A: No Sub Type Information) - This DTC sets if the PSCM receives an invalid or unknown message from the IPMA instead of valid lane information.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.