Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 XLT, 3.5L ENG VIN G, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - PINPOINT TESTS (EXCEPT DIESEL & HYBRID) (A TO H)PINPOINT TESTS FB: POWER TAKE OFF (PTO)TEST PROCEDURE
2021 Ford Transit-350 XLT, 3.5L Eng VIN G, RWD
Test Procedure
2021 Ford Transit-350 XLT, 3.5L Eng VIN G, RWDSECTION Test Procedure
- FBI PTO INDICATOR LAMP
Did you come to this pinpoint test for an always on/never on PTO indicator?
Yes No GO to FB5 GO to FB2 - FB2 PTO NOT WORKING CORRECTLY: CHECK THE PTO INDICATOR LAMP OPERATION NOTE: The following conditions must be met before the PTO engages:
- engine at normal operating temperature
- accelerator pedal is released
- transmission fluid temperature (TFT) within normal operating temperature
- parking brake is applied
- brake pedal is released
- automatic transmission is in the PARK position
- manual transmission - the clutch pedal is released
NOTE: This step requires operating the PTO component. Refer to the aftermarket manufacturer for the PTO operating instructions. Follow all safety precautions.- Ignition ON, engine running.
- Activate the PTO switch.
Does the PTO indicator illuminate?
Yes No GO to the aftermarket PTO mechanical manual. GO to FB3 - FB3 CHECK THE INTEGRITY OF THE PTO SWITCH AND THE PTO SWITCH CIRCUIT
- Access the PCM and monitor the PTO_STATUS (MODE) PID.
- Cycle the PTO switch, from off to on to off.
Does the PTO PID change state?
Yes No GO to FB4 REPAIR the PTO circuit or switch as necessary.
Clear the PCM DTCs. REPEAT the self-test. - FB4 CHECK THE PTOIR_V PID STATE IN THE PCM NOTE: The PTOIR_V PID represents an analog input which reflects the user requested engine speed.
- Access the PCM and monitor the PTOIR_V (VOLT) PID.
- Cycle the PTO switch,
Does the PTOIR_V PID change state?
Yes No GO to FB5 REPAIR the PTO RPM circuit or switch as necessary.
Clear the PCM DTCs. REPEAT the self-test. - FB5 CHECK THE PTOIL PID STATE IN THE PCM
- Access the PCM and monitor the PTOIL (MODE) PID.
- Cycle the PTO switch,
Does the PTOIL PID change state?
Yes No GO to the aftermarket PTO mechanical manual. REPAIR the circuit as necessary.
Clear the PCM DTCs. REPEAT the self-test.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.