Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 XL, 3.5L ENG VIN G, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 423 (FUEL CHARGING AND CONTROLS - 3.0L POWER STROKE DIESEL)REMOVAL AND INSTALLATIONFUEL PUMP DRIVER MODULE (FPDM)REMOVAL
2021 Ford Transit-350 XL, 3.5L Eng VIN G, RWD
Fuel Pump Driver Module (FPDM): Removal
2021 Ford Transit-350 XL, 3.5L Eng VIN G, RWDSECTION Removal
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The fuel pump driver module is located on top of a rear frame crossmember.
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- Disconnect the fuel pump driver module electrical connector.
- Remove the fuel pump driver module bolts and then remove the fuel pump driver module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.