Short Term Fuel Trim

If the oxygen sensors are warmed up and the PCM determines the engine can operate near the 14.7 to 1 (9 to 1 E100) stoichiometric air to fuel ratio, the PCM enters closed loop fuel control mode. Since an oxygen sensor can only indicate rich or lean, the fuel control strategy continuously adjusts the desired air to fuel ratio between rich and lean causing the oxygen sensor to switch around the stoichiometric point. If the time between rich and lean switches is the same, then the system is actually operating at stoichiometric. The desired air to fuel control parameter is called short term fuel trim (SHRTFT1 and SHRTFT2) where stoichiometric is represented by 0%. Richer (more fuel) is represented by a positive number and leaner (less fuel) is represented by a negative number. Normal operating range for short term fuel trim is between -25% and 25%. Some calibrations have time between switches and short term fuel trim excursions that are not equal. These unequal excursions run the system slightly lean or rich of stoichiometric. This practice is referred to as using bias. For example, the fuel system can be biased slightly rich during closed loop fuel to help reduce nitrogen oxides (NO_x ).

Values for SHRTFT1 and SHRTFT2 may change significantly on a scan tool as the engine is operated at different RPM and load points. This is because SHRTFT1 and SHRTFT2 react to fuel delivery variability that changes as a function of engine RPM and load. Short term fuel trim values are not retained after the engine is turned OFF.