Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Pump Monitor (FPM) - All Others: Notes
The fuel pump control module communicates diagnostic information to the PCM through the FPM circuit. This information is sent by the fuel pump control module as a duty cycle signal. The duty cycle signals that may be sent are listed in the following tables.
| Duty Cycle | Comments |
|---|---|
| 20% | This duty cycle indicates the fuel pump control module is receiving an invalid duty cycle from the PCM. |
| 60% | This duty cycle indicates the fuel pump control module is functioning normally. |
| 80% | This duty cycle indicates the fuel pump control module is detecting a concern with the secondary circuits. |
| Duty Cycle | Comments |
|---|---|
| 20% | This duty cycle indicates the fuel pump control module is receiving an invalid duty cycle from the PCM. |
| 40% | For vehicles with event notification signal, this duty cycle indicates the fuel pump control module is receiving an invalid event notification signal from the RCM. For vehicles without event notification signal, this duty cycle indicates the fuel pump control module is functioning normally. |
| 60% | For vehicles with event notification signal, this duty cycle indicates the fuel pump control module is functioning normally. |
| 80% | This duty cycle indicates the fuel pump control module is detecting a concern with the secondary circuits. |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.