Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, RWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWARNING SYSTEMSLANE KEEPING SYSTEMDIAGNOSIS AND TESTINGLANE KEEPING SYSTEMPINPOINT TESTSPINPOINT TEST AX
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, RWD
Pinpoint Test Ax
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, RWDSECTION Pinpoint Test Ax
- Normal Operation and Fault Conditions
Front camera temporarily not available - message in IPC.
Possible Sources
- Temporary over temperature condition
- AX1 CHECK FOR CORRECT IPMA (IMAGE PROCESSING MODULE A) OPERATION
- Ignition ON.
- Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs) for the module in question.
Was an obvious cause found?
Yes REMOVE the vehicle from direct sunlight, RECHECK after 10 minutes. No The repair is complete.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.