Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Connector End View (C810) - INLINE
| Inline: | Description | Color | Harness | Base Part # | Service Pigtail | |||
|---|---|---|---|---|---|---|---|---|
| C810 | INLINE | BK | 19L54014401 | See Below | ||||
MALE
Harness
19L540
FEMALE
Harness
14401
| Terminal Part Number | Service Part Number | Size |
|---|---|---|
| 97BG-14421-ADA | Not Available | |
| 97BG-14474-AEA | LU2Z-14474-CA | 1.50 |
| 97BG-14474-ADA | LU2Z-14474-CA | 1.50 |
| 97BG-14421-AEA | Not Available |
| Pin | Circuit | Gauge | Qualifier | Terminal Part Number | ||
| 1 | CPL54 (GY-BU) | 17 | 97BG-14421-AEA | |||
| 2 | CPL11 (GY-BN) | 17 | 97BG-14421-AEA | |||
| 3 | CPL39 (YE) | 20 | 97BG-14421-ADA | |||
| Pin | Circuit | Gauge | Qualifier | Terminal Part Number | ||
| 1 | CPL54 (GY-BU) | 17 | 97BG-14474-AEA | |||
| 2 | CPL11 (GY-BN) | 17 | 97BG-14474-AEA | |||
| 3 | CPL39 (YE) | 22 | 97BG-14474-ADA | |||
Available Pigtail Kits
Pigtail Kit Part Number WPT-1220
Service Part Number:
BU2Z-14S411-AXA
Gauge:
16
Pin material:
Silver
Cavities:
4
Vehicle Uses:
- Sensor - Knock
Pigtail Kit Part Number WPT-1339
Service Part Number:
3U2Z-14S411-SPC
Gauge:
16
Pin material:
Silver
Cavities:
4
Vehicle Uses:
- Actuator - Door Lock - Decklid/Liftgate
- Actuator - Intake Manifold Valve
- Coil - Ignition
- Lamp - Front Cornering/Turn
- Lamp - Park/Turn
- Sensor - Intake Manifold Runner Control
- Sensor - Manifold Absolute Pressure (MAP)
- Sensor - Manifold Pressure/Intake Temperature
- Sensor - Turbine Shaft Speed
- Sensor - Turbo Intake Pressure/Temperature
- Switch - Sliding Door Contact
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.