SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTMEMORY MODULESENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSP0206 - CYLINDER 6 INJECTOR A CIRCUIT/OPEN
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, RWD

P0206 - Cylinder 6 Injector A Circuit/Open

2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, RWDSECTION P0206 - Cylinder 6 Injector A Circuit/Open
DTC DESCRIPTION P0206 - CYLINDER 6 INJECTOR A CIRCUIT/OPEN

Description:  The comprehensive component monitor (CCM) monitors the operation of the fuel injector drivers in the PCM. This DTC sets when the fuel injector circuitry is inoperative.
Possible Causes: 
  • VPWR circuit open (if equipped)
  • INJ6 circuit open
  • INJ6 circuit short to ground (direct injection vehicles)
  • INJ6 circuit short to voltage (direct injection vehicles)
  • INJ6RTN circuit open (if equipped)
  • INJ6RTN circuit short to ground (if equipped)
  • INJ6RTN circuit short to voltage (if equipped)
  • Damaged fuel injector 6
Diagnostic Aids:  For direct injection vehicles, the INJ6_F PID flags a concern. For all others, the INJ6_F PID flags equals YES.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
Aviator, Edge 2.7L, Expedition, Explorer, F-150, Mustang 5.0L, Nautilus 2.7L, Navigator,
Transit		 GO to Pinpoint Test DI.
All others GO to Pinpoint Test KG.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.