SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESMODULE CONFIGURATIONDESCRIPTION AND OPERATIONMODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTIONSYSTEM OPERATIONMODULE CONFIGURATION AND PARAMETER CHART
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, RWD

Module Configuration and Parameter Chart

2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, RWDSECTION Module Configuration and Parameter Chart

The chart describes specific module configuration information:

Module Name Module Address Programmable Module Installation (PMI) Available Reprogram/Flash Capable Requires Adaptive Learning or Calibration Available Programmable Parameters
AHCM 7E3 Yes Yes No None
APIM 7D0 Yes Yes No None
ABS module 760 Yes Yes No None
ACM 727 Yes Yes No None
AWD module 703 Yes Yes No None
BCM 726 Yes Yes No None
CCM 764 Yes Yes Radar horizontal and vertical alignment calibration None
DCMH 7B4 Yes Yes No None
GFM2 (upfitter switch) 7D2 No No No None
GWM 716 Yes Yes No None
HCM 734 Yes Yes No None
HVAC module 733 Yes Yes No None
IPC 720 Yes Yes No None
IPMA 706 Yes Yes Camera alignment None
IPMB 7B1 Yes Yes No None
PAM 736 Yes Yes No None
PCM 7E0 Yes Yes No Vehicle speed limiter configuration
RBM 763 Yes Yes No None
PSCM 730 Yes Yes No None
RTM 751 Yes Yes No None
RCM 737 Yes Yes No None
SODL 7C4 Yes Yes No None
SODR 7C6 Yes Yes No None
SCCM 724 Yes Yes No None
TBM 757 No No No None
TRM 791 Yes Yes No None
TCM 7E9 No No No None
TCU 754 Yes Yes No None
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.