Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 8 (STARTING SYSTEM - 3.5L ECOBOOST (235KW/320PS))DIAGNOSIS AND TESTINGSTARTING SYSTEMDTC CHARTS
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD
DTC Charts
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION DTC Charts
WARNING: This page is about a different variant/trim than selected.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
Diagnostic Trouble Code Chart
| Module | DTC | Description | Action |
|---|---|---|---|
| PCM | P06E4 | Control Module Wake-up Circuit Performance | GO to Pinpoint Test E |
| PCM | P06E9 | Engine Starter Performance | If engine cranks, Refer to ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID) . If the engine does not crank, GO to Pinpoint Test A |
| PCM | P162F | Starter Motor Disabled - Engine Crank Time Too Long | GO to Pinpoint Test F |
| PCM | P2535 | Ignition Switch Run/Start Position Circuit High | GO to Pinpoint Test C |
| BCM | C113A:11 | Wakeup Control: Circuit Short To Ground | GO to Pinpoint Test D |
| BCM | C113A:15 | Wakeup Control: Circuit Short To Battery Or Open | GO to Pinpoint Test D |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.