SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 10 (FUEL CHARGING AND CONTROLS - 3.5L ECOBOOST (235KW/320PS))REMOVAL AND INSTALLATIONFUEL PUMP DRIVER MODULE (FPDM)REMOVAL
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD

Fuel Pump Driver Module (FPDM): Removal

2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Removal
WARNING: This page is about a different variant/trim than selected.

All Vehicles 

  1. The fuel pump driver module is located on the front side of the crossmember above the fuel tank. Refer to: Fuel Charging and Controls - Component Location .

    Full Body 

  2. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
  3. Disconnect the fuel pump driver module electrical connector.
    GFD566156Courtesy of FORD MOTOR COMPANY
  4. Release the fuel pump driver module retaining tab, then remove the fuel pump driver module from the bracket.
    GFD566157Courtesy of FORD MOTOR COMPANY
  5. Only if needed, remove the fuel pump driver module bracket bolts, then remove the bracket.
    GFD566158Courtesy of FORD MOTOR COMPANY

    Chassis Cab 

  6. Remove the fuel tank. Refer to: Fuel Tank .
  7. Disconnect the fuel pump driver module electrical connector.
    GFD566159Courtesy of FORD MOTOR COMPANY
  8. Release the fuel pump driver module retaining tab, then remove the fuel pump driver module from the bracket.
    GFD566160Courtesy of FORD MOTOR COMPANY
  9. Only if needed, remove the fuel pump driver module bracket bolts, then remove the bracket.
GFD566161Courtesy of FORD MOTOR COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.