Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test X : DTC B19A3: Notes
Refer to Climate Controlled Seats for schematic and connector information.
Normal Operation and Fault Conditions
The SCME supplies voltage and ground to the driver seat cushion blower motor. The SCME also sends a speed control voltage signal to the blower motor to control blower speed.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B19A3 | Driver Seat Cushion Blower Speed Short to Battery | If the driver seat cushion blower speed circuit is shorted to voltage, the SCME shuts down the driver seat system and sets this DTC. |
Possible Causes
- Wiring, terminals or connectors
- Cushion blower motor
- SCME
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.