Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 613 (CRUISE CONTROL)DIAGNOSIS AND TESTINGCRUISE CONTROLSYMPTOM CHART(S)SYMPTOM CHART: CRUISE CONTROL
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD
Symptom Chart: Cruise Control
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Symptom Chart: Cruise Control
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
Symptom Chart
| Condition | Possible Sources | Actions |
|---|---|---|
| The cruise control is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test A |
| The cruise control is inoperative - with adaptive steering | Refer to the Pinpoint Test | GO to Pinpoint Test B |
| The cruise control indicator lamp is never/always on | Refer to the Pinpoint Test | REFER to: Instrumentation, Message Center and Warning Chimes . |
| The cruise control switch is inoperative/does not operate correctly | Refer to the Pinpoint Test | GO to Pinpoint Test A |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.