Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 604 (LANE KEEPING SYSTEM)DIAGNOSIS AND TESTINGLANE KEEPING SYSTEMPINPOINT TESTSPINPOINT TEST AV: U3000:51
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD
Pinpoint Test Av: U3000:51
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Pinpoint Test Av: U3000:51
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Lane Keeping System - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition IPMA U3000:51 Control Module: Not Programmed This continuous memory DTC sets when the IPMA not programmed. Possible Sources
- Suspect module
- IPMA
- AV1 INSTALL A NEW SUSPECT MODULE
- Ignition OFF.
- INSTALL a new module in question. REFER to: Image Processing Module A (IPMA) .
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS and follow the instructions for the applicable TSB, GSB, SSM or FSA. No The repair is complete.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.