Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 604 (LANE KEEPING SYSTEM)DIAGNOSIS AND TESTINGLANE KEEPING SYSTEMPINPOINT TESTSPINPOINT TEST AF: U2300:55
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD
Pinpoint Test AF: U2300:55
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Pinpoint Test AF: U2300:55
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Lane Keeping System - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition IPMA U2300:55 Central Configuration: Not Configured This continuous memory DTC can set in IPMA due to incomplete or incorrect PMI procedures. Possible Sources
- IPMA concern
- AF1 CHECK FOR THE CORRECT PMI (PROGRAMMABLE MODULE INSTALLATION) PROCEDURE
- Ignition ON.
- Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs) for the module in question.
Is DTC U2300:55 still present?
Yes CHECK the vehicle service history for recent service actions related to this module. If there have been recent service actions with this module, INSTALL As-Built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built. REFER to: Module Programming . If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. REFER to: Image Processing Module A (IPMA) . No The repair is complete.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.