Auxiliary Power Point: Removal

2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Removal
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the power point cover.
    GFD562000Courtesy of FORD MOTOR COMPANY
  2. Position the power point extractor so that it engages in the adjacent slots in the power point socket. Remove Special Service Tool: 501-194 Remover, Power Point.
    GFD562001Courtesy of FORD MOTOR COMPANY
    1. Install the receiver cup.
    2. Install and tighten the wing nut. Remove Special Service Tool: 501-194 Remover, Power Point.
    GFD562002Courtesy of FORD MOTOR COMPANY
  3. Tighten the wing nut to pull the power point socket out of the retainer. Remove Special Service Tool: 501-194 Remover, Power Point.
    GFD562003Courtesy of FORD MOTOR COMPANY
  4. Disconnect the electrical connector.
GFD562004Courtesy of FORD MOTOR COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.