Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021TRANSIT-350 HD BASE, VAN CARGO EXTENDED, 3.5L ENG VIN 8, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 593 (ELECTRONIC ENGINE CONTROLS - 3.0L POWER STROKE DIESEL)DIAGNOSIS AND TESTINGCRANKSHAFT POSITION SYSTEMDTC CHART(S)DIAGNOSTIC TROUBLE CODE (DTC) CHART
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD
Diagnostic Trouble Code (DTC) Chart
2021 Ford Transit-350 HD Base, Van Cargo Extended, 3.5L Eng VIN 8, AWDSECTION Diagnostic Trouble Code (DTC) Chart
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
Diagnostic Trouble Code Chart
| Module | DTC | Description | Action |
|---|---|---|---|
| PCM | P0016:00 | Crankshaft Position - Camshaft Position Correlation - Bank 1 Sensor A: No Sub Type Information | GO to Pinpoint Test D |
| PCM | P0315:00 | Crankshaft Position System Variation Not Learned: No Sub Type Information | GO to Pinpoint Test D |
| PCM | P0335:00 | Crankshaft Position Sensor A Circuit: No Sub Type Information | GO to Pinpoint Test D |
| PCM | P0336:00 | Crankshaft Position Sensor A Circuit Range/Performance: No Sub Type Information | GO to Pinpoint Test D |
| PCM | P033F:00 | Crankshaft/Camshaft Loss Of Synchronization: No Sub Type Information | GO to Pinpoint Test D |
| PCM | P034B:00 | Crankshaft Position Sensor - Crankshaft Direction Incorrect: No Sub Type Information | GO to Pinpoint Test D |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.